Battery testing solution
Define the Right Test Gates for Battery PACK Production
Testing should be tied to a specific production decision: incoming-cell grouping, weld verification, BMS validation or final PACK acceptance.
Who this solution is for
PACK assemblers and integrators that need controlled screening, sorting, grading, protection-board or end-of-line test stages.
Typical project requirements
- Cell chemistry, format and voltage range
- Required OCV/IR accuracy and channel count
- Capacity or charge/discharge test profile
- BMS/protection-board functions
- Insulation and safety checks
- Data logging, barcode and MES requirements
Recommended equipment routes
Testing & Sorting
OCV, IR, grading and polarity inspection.
BMS / EOL Testing
BMS and completed PACK validation.
PACK Equipment Hub
See the wider production context.
Selection and implementation logic
Confirm measurement range, accuracy, channels, cycle profile, fixtures, data retention and pass/fail logic. Avoid choosing only by channel count.
Specifications and deliverables remain subject to final project configuration and the signed technical/commercial agreement.
Frequently asked questions
Is OCV sorting enough before PACK assembly?
Usually no. OCV is one input; internal resistance, capacity consistency, aging history and the project quality plan may also matter.
What belongs in EOL testing?
The scope can include voltage, internal resistance, insulation, communication, BMS functions and project-specific safety checks.
Can test data be exported?
Data interface and export requirements should be specified before quotation so the correct software and integration scope can be confirmed.
Information needed for a proposal
Send your application, location, quantity or production target, technical requirements, available utilities and timeline.